<kuid2:368725:17000:2> Mesh library of NSWGR buffers, couplers and hoses

Скачать

Mesh library representing buffers and the idle and coupled state of various types of couplers and air hoses in use by NSWGR in the mid 20th century.
Attachment points for library items must be provided in the traincar models which reference the library. Only 2 attachment points are required: 'a.couple0' for the front coupler and hose, and 'a.couple1' for the rear.
The attachment points should have an X,Y,Z position of (0,y,0) where 'y' is flush with the buffer beam onto which the coupler and air hose is to attach. The orientation of 'a.couple1' must be rotated on its Z-axis by 180 degrees.
If no couplers or hoses are required at one end of a vehicle, omit the attachment point for that end.
For the library meshes to appear correctly in game, the traincar models of NSWGR rolling stock must conform to the following NSWGR standards of the mid 20th century:
- Centre of wagon end beam to which coupler attaches is 1.041m above rail head
- Separation between coupled wagon end beams is 1.12m for buffered wagons and 0.845m for knuckle-coupled wagons. a.limfront/a.limback, the contact point between the front/back of a buffered wagon and another to which it is coupled, is therefore 1.12/2 = 0.56m more negative/positive on the y-axis than is a.couple0/1. For knuckle couplers, the difference is 0.845/2 = 0.423m.
- Over the transition from buffered to knuckle couplers in the 1940s and 1950s, some locomotives were fitted with dual couplers, known as 'unit drawgear', that could be swung 90 degrees to activate either a screwlink or knuckle coupler. The screwlink of dual couplers had the standard contact point of buffered couplings. However, the knuckle coupler of unit drawgear projects further from vehicle body that a standard knuckle coupler. For this reason, a separate airhose coupled-state mesh is required for dual-coupler knuckles.
The toggling between the idle and coupled states of couplers and hoses from the library must be handled by the script of each traincar which employs the meshes from the library. The script must detect whether each end of a vehicle is coupled or not, then assert the visibility of the appropriate mesh from the library.
The traincar script can be assisted in this decision by making calls to the Active Coupling System (ACS) Library, <kuid2:60850:89100:9>.

Here is a list of LM files in this library. Since LOD is implemented for all mesh types, specify LM files, not IM files, in any reference to the library in the config file of a traincar asset.
buffer_pair1.lm
buffer_pair2.lm
airhose_idle.lm, airhose_buffered_coupled.lm, airhose_knuckle_coupled.lm, airhose_dual_knuckle_coupled.lm
3link_idle.lm, 3link_coupled.lm
screwlink_idle.lm, screwlink_coupled.lm
knuckle_idle.lm, knuckle_coupled.lm
dual_screwlink_idle.lm, dual_screwlink_coupled.lm
dual_knuckle_idle.lm, dual_knuckle_coupled.lm