This represent a very large casting assembly which is too long and too heavy for a single 4 bogey flatcar and must be
suspended between two 4-bogey flatcars. Assemble this car in Surveyor as follows:
1. Place Hicapyflat_10_Body on the track.
2. Place two Hicapyflat_9_Bodys on the track a little bit past the ends of Hicapyflat_10_Body (not underneath).
3. Rotate one of the Hicapyflat_9_Bodys to get the brake wheel out of the load.
4, Place 2 Hicapyflat_Bolsters under each Hicapyflat_9_Body by placing them about half way between the center of the body and each end.
5. Move the Hicapyflat_9_Body assemblies under Hicapyflat_10_Body.
6. If all went well there will only 1 red and 1 green arrow and the item will move as a unit.
Тип: traincar