This is a full circle roundhouse with 65 stalls, 3 blocked up stalls, and 4 access tracks in 5 degree increments with
a 130 ft turntable. Full circle roundhouses were rare but some did exist. When traffic generated a need for more stalls railroads
preffered building another half circle roundhouse (prefferably on the other side of the tracks to avoid engines having to constantly
cross the main line). The more stalls a roundhouse has the more the turntable is used. In a full circle roundhouse the turntable itself
becomes a bottle neck. Occasionally there wasn't room for the second roundhouse so a full circle one was built. The 4 access tracks
are on 16 ft centers. Three stalls are blocked out (without tracks) because there are two limits on the angle values above (72 entries
and 256 characters. This hits the character limit at the 69th track.
NOTE!!! This item can be modified after download by manipulating the config file mesh-table. As downloaded all stalls have rear walls
with 3 windows and the smoke jacks are toward the front of the stalls. Extra image files are in the folder so 2 rear walls can be
replaced by walls with a locomotive sized open door, the smoke jacks can be moved to the rear of the stalls, or you can have smoke
jacks at the front and rear of the stalls.
In the config file mesh-table:
1. To put the smoke jacks at the rear of the stalls, change the 12 in Part_12 to13 (in 2 places).
2. To put the smoke jacks at both the front and rear of the stalls, change the 12 in Part_12 to 14 (in 2 places).
3. To replace the windowed rear wall with a doored rear wall for stall 1, change the 8 in Part_8 to 10 (in 2 places).
4. To replace the windowed rear wall with a doored rear wall for stall 36, change the 9 in Part_9 to 11 (in 2 places).
Connect tracks as desired (to repair facilities for example). Don't delete the unused files (you might want to go back).