In 1964 the Victorian Railways built some large Louvre Van's as Prototypes for a new design of high capacity Van and where classified as VHX with a total of 20 built, in 1972 another 50 where built at Ballarat Workshops with lightened frames, 4 feet longer and classified as VSX becoming the largest Van Victoria had built, these where used all over Australia going on to Standard Gauge at Albury and into New South Wales, Broad Gauge into South Australia and bogie exchanged at Adelaide going into Western Australia, the design was so successful another 2 where built March 1973 then another 198 where built from April 1974 till 1976 at Ballarat Workshops. From 1979 some where recoded VLEY to remove them out of the bogie exchange to be used for Freight Centre Traffic, from late 1981 most where recoded back to VLEX with a few still in service as VLEY till early 1983 with the last being coded back to VLEX, a few of the VLEY and VLEX where recoded VLNX in 1981 for News Print Traffc.
They carried General Goods in crates and Pallets and where seen around Mildura, Warnambool, Geelong, Westall, Spencer St Yard, North Melbourne, Port Melbourne, Melbourne East Yard, Flinders St Yard, Tottenham Yard, Castlemaine, Bendigo, Wodonga, Albury, Maryvale, Bacchus Marsh, Ararat, Portland, Sale, Newport Goods Yard, Shaws Siding, Wangaratta, Woodend, Dandenong, Morwell, Williamstown Pier and Ballarat.
On Standard Gauge they where seen Ubonia WA, Port Augusta SA, Zanthus WA, Wodonga NSW, Wodonga Coal Siding NSW, Albury NSW, Haig WA, South Dynon Vic and Munistone NSW.
In 1978 number 809 was destroyed at Ubonia, WA and in 1979 number 834 was destroyed at Zanthus, WA
This model represents the Type 1 built from April 1972 to Augest 1972 and numbered 801 to 850 on Standard Gauge, Steps created by Zec.
Mass: 25.26 tonnes (empty) 75 tonnes (loaded)
Load Capacity: 50 tonnes
Max Speed: 96 km/h
Axle Load: 19 tonnes
Brake Cylinder: (1) 305mm x 305mm Air Slack Adjuster
Brake Ratio: 33.5% (Loaded) ~ 53.3% (Empty) Load compensating
Тип: traincar