Some flatcar loads while relativly small were be so heavy they exceded the axle loading limit for a standard (2 bogie) flatcar.
Several Railroads modified flatcars by replacing the normal 2 bogies with two bolsters with bogies at each end which then attached to the
underside of the car body in the same manner as the original single bogie. This reduces the axle loading by almost half. This is the body section
with an additional attachment point (a.bog4) in the center of the car at at the surface of the boards. Down-loaders can make custom loads and
attach them to this car, Having several custom loads will allow changing them by naking the appropriate changes in the config file. Assemble this
car in Surveyor by placing the body section on the track then select the bolster (kuid2:210518:6501:1) and place them half way between the center
of the body and each end.
To add or change a custom load:
1. Make a custom load and export it to Trainz as (kind) bogey.
2. Replace the kuid for bogey-4 with the kuid of the custom load.
3. Add the name and kuid of the custom load to the kuid-table.
Тип: traincar