A driver (schedule) command to perform throttle-controlled custom coupling to a consist waiting along the way. The procedure is as follows. (1) Navigate to the consist you want coupling by using Mutton's PATH rule and SETPATH command. Make sure that signaling option is turned off in the setpath definition (otherwise, setpath request will never be granted due to the presence of a vehicle on the track). (2) Use ResetTrainDirection, SwitchDCCGear, and/or SetDCCThrottle commands (available on DLS), if necessary to setup your train to move in the right direction and desired throttle speed. (3) Apply TCouple command to move the train to the consist for coupling. The driver (schedule) command ends once your train comes to a full stop after coupling. Note that the predecessor of this command, DCC_Couple, is no longer compatible with some of the commands in this pack, and it is therefore obsoleted by TCouple command.
Тип: Команда