Part C Steam powered and permanently mounted A-frame unloader for use with log dump set. This section is placed as required with the other parts of the log dump set. Ensure spacing is correct by viewing the donkey exhaust stack from above and checking that it is not ovalized. Adjust length as required to make the donkey stack evenly round. Can be placed on shallow water or (preferred) with rear of donkey deck at water's edge with tie-back spar fully on land. There is enough room between the donkey deck and the tie-back spar to run a spur track if necessary. This spline should be exactly 6meters in length. Maximum height is 10m above absolute ground. Modified textures are homegrown and from originals by P.Pardoe-Matthews and Mike Sutton, used with permission. Uses the 3 ft No Ballast track from Mike10 Kuid 35412 38066
swivel.bmp |
822 B |
log_dump_c2.im |
109.1 kB |
sg_timber42c-128_b3.texture.txt |
42 B |
yellowpine2_brn_256.texture.txt |
42 B |
sg_colour4-64.texture.txt |
36 B |
sg_timber37-64.texture.txt |
37 B |
sg_colour4b-64.texture.txt |
37 B |
sg_roof-iron3b-128.texture.txt |
41 B |
sg_surface100-16.texture.txt |
39 B |
pulley1_64.texture.txt |
33 B |
swivel-swivel_alpha.texture.txt |
53 B |
chain_alpha.texture.txt |
34 B |
chain-chain_alpha.texture.txt |
51 B |
yellowpine_2_128_brn.texture.txt |
43 B |
sg_surface58-64.texture.txt |
38 B |
sg_timber42c-128_b3.bmp |
48.1 kB |
yellowpine2_brn_256.tga |
192.0 kB |
sg_colour4-64.bmp |
12.1 kB |
sg_timber37-64.bmp |
12.1 kB |
sg_colour4b-64.bmp |
12.1 kB |
sg_roof-iron3b-128.bmp |
48.1 kB |
sg_surface100-16.bmp |
822 B |
pulley1_64.tga |
12.0 kB |
swivel_alpha.bmp |
822 B |
chain.bmp |
1.6 kB |
chain_alpha.bmp |
1.6 kB |
yellowpine_2_128_brn.tga |
48.0 kB |
sg_surface58-64.bmp |
12.1 kB |
Общий объём файлов: |
511.5 kB |