A driver command to perform velocity-controlled custom driving through a selected trackmark. The procedure is as follows. (1) Navigate to the selected trackmark by using Mutton's PATH rule and SETPATH command. (2) Use ResetTrainDirection, SwitchDCCGear, and/or SetTargetSpeed commands (included in this pack) if necessary to set your train for correct moving direction and desired target speed. (3) Apply VCDriveViaTrackmark command to drive the train through the trackmark. The driver schedule command ends once your train enters the trackmark. Make sure that correct trackmark is chosen from the menu.
VERSION 0.0
PREREQUISITE: WorkTable rule and SetTargetSpeed command
OPTIONAL: ResetTrainDirection, SwitchDCCGear
RECOMMENDED: Mutton's PATH rule and SETPATH command.
NOTES: Check out SetTargetSpeed command to find out how you can create target speed labels using WorkTable rule editor. A target speed label must previously be issued by SetTargetSpeed command before using this command; otherwise, your train may not move.
Тип: Команда